Changing the Screen Protector
To change the screen protector, you need the following:
Spudger pry tool
Replacement screen protector kit:
Replacement screen protector (ACC-G8-SP-XXX)
Isopropyl alcohol pads
Microfiber cloth
Canned air
Note: Always perform maintenance procedures in a clean, dust-free environment.
CAUTION: Ensure G8 is powered off before beginning this procedure.
- Detach the cartridge from G8. For detailed steps, refer to Installing and Replacing the Cartridge in the Cartridge Technical User Manual.
- Use the Spudger pry tool to lift up a corner of the old screen protector.
- Peel off the old screen protector.
- Inspect the screen for broken glass before cleaning it, as shards can scratch the screen.
- Use canned air to blow off the screen to remove any glass shards or other debris.
- Clean the screen with the isopropyl alcohol wipe. Ensure the screen is completely free of all residue and that there are no marks on the screen.
- Use the microfiber cloth to dry any remaining marks on the screen.
- Peel the protective film from the sticky side of the replacement screen protector by pulling the bottom pull tab.
- Place the replacement screen protector on G8's screen. Start by aligning the bottom edges of the screen protector with G8's screen.
- Align the rest of the screen protector with G8's screen.
- Push out any air bubbles between the screen protector and the G8's screen. Start in the middle and push the bubbles out toward the edges.
- Reinstall the G8 cartridge. For detailed steps, refer to Installing and Replacing the Cartridge in the Cartridge Technical User Manual.