The procedure to place and anchor the 5- or 25-unit G6 multi-charger on a horizontal surface, using the screw and keyholes in the base.

1. Using the measurements provided, mark the areas where the screws will go.
2. Using a drill bit and screws appropriate for the surface you are drilling into, drill into the surface, using your marks as guides. Ensure the hole is shallower than your screw length.
3. Use a screwdriver to fit the screws that go underneath the charger into the holes you drilled.
   CAUTION:

   Do not insert the screws that go through the tabs at the back of the panel yet.

4. When all screws for the keyholes on the bottom of the charger are installed, lift the multi-unit charger, and lower it down onto the screws. Slide the charger forward to lock the charger in place.
5. Use a screwdriver to fit the screws that go through the tabs on the back of the charger in place.
6. Plug the 24V AC/DC adapter into the 24V DC input port on the back of the multi-unit charger, then attached the supplied AC power cord to the 24V AC/DC adapter.
7. Plug the AC power cord in to an AC outlet with a voltage within the AC input range of the adapter.