home

EXO

G6G7G8EXOCartridges and SensorsLocation BeaconBlackline LiveBlackline AnalyticsLoner MobileNotifications
G6G7G8EXOCartridges and SensorsLocation BeaconBlackline LiveBlackline AnalyticsLoner MobileNotifications

Help Center

Search the Help Center

Show Contents

thumbnailEXO

Installing EXO Components

Installing the EXO Pump components

Important:

Ensure that the EXO Diffusion components have been uninstalled. For detailed instructions, refer to Uninstalling EXO Diffusion Components.

  1. Install the pump gas chamber:
    1. Using your fingers, attach the pump gas chamber coupling to EXO’s inlet tubing.
    2. Carefully push the inlet tubing back into EXO’s interior.
    3. Slide the pump gas chamber into its slot and secure the chamber using two screws and washers, ensuring they are snug but not over-tight.
  2. Install the pump module:
    1. Place EXO on its side with the module opening facing upwards.
    2. Check inside the module opening to see if the inlet tubing is crimped. Ensure the clip is correctly attached and, if necessary, gently adjust the inlet tubing by sliding it through the tube clamp to elongate the loop.
      Important:

      During any adjustment of the inlet tubing and clamp, take care not to dislodge the display ribbon cable connector. If you dislodge the connector, gently reconnect it before proceeding.

      Figure 1. Ideal tubing position for optimal gas flow
    3. Attach the pump module to EXO using the inlet tubing quick-connect.
    4. Line up the pump module’s male connector with EXO’s female connector and tuck the tubing under EXO’s internal frame.
    5. Lower the pump module into the opening until it is flush with EXO’s frame. Ensure that the inlet tubing remains tucked under EXO’s internal frame.
      Warning:

      The pump module is designed to lay flush with the opening. Make sure the inlet tubing is not pinched between the module and EXO’s frame.

      Warning:

      DO NOT force or otherwise use undue pressure when lowering the module into place. Forcing the module into place or not lining up the connectors may result in permanent, unrepairable damage to EXO. Refer to the following schematics for more information.

      Figure 2. Location of EXO female connector for pump module
      Figure 3. Location of EXO pump module male connector
      Figure 4. EXO with properly connected pump module
    6. Secure the pump module to EXO using the screws provided, ensuring they are snug but not over-tight.
    7. Stand EXO upright.
  3. Insert the gas sensor cartridge that was previously removed by sliding it into its slot in the pump gas chamber.
  4. Place the pump cartridge cover on EXO, ensuring that you properly orient the cover over top of the front enclosure. Tighten the cover’s screws, ensuring they are snug but not over-tight.

EXO Pump is ready for operation.

Note:

EXO Pump’s pump inlets must be assigned before using the device. For detailed instructions on configuring pump inlets, refer to the EXO Technical User Manual.

Important:

Although EXO Pump inlet filters are an optional accessory, Blackline recommends always installing inlet filters to maintain the pump in good condition.
G7_EXO

Last updated: June 11, 2026