How to install the EXO Satellite Module.

1. Power off EXO.
2. Ensure EXO is in a safe environment with a clean atmosphere.
3. Use the hex key to loosen the two self-retaining screws at the top of the battery on the back of EXO.
4. Pull the top of the battery away from EXO to remove the battery.
   Note: When EXO is vertical, the battery will lean away from EXO, allowing you to grip and remove the battery.
5. Use the Philips screwdriver to remove the clear cover to allow access to the main EXO board. Take care to not misplace the screws.
   
6. Use needle-nose pliers to pull the white-coded radio-frequency cable is fixed to the main EXO board loose. Take care not to detach the socket from the board.
   
7. There are four silver standoffs and two pin connectors on the main board. Place the Satellite Module so that its pin connectors align with the connectors on the main board. This should also allow for the captive screws in the Satellite Module to align with the four standoffs.
   
8. Once the connectors and screws are aligned, press down and use the Philips screwdriver to fasten the Satellite Module to the board with the attached screws.
   
9. Connect the white-coded cable to the socket on the Satellite Module and press down until it clicks into place.
   
10. Re-attach the clear cover over the board and screw it into place.
11. Hold the battery at a 45-degree angle with the bottom pointing towards EXO.
12. Place the battery bottom first into EXO's battery slot.
13. Push the top of the battery towards EXO until it sits flush.
14. Use the hex key to tighten the two screws at the top of the battery.
    Note: NOTE: The screws should be snug, but not over-tight.