Configuring a Gas Detection Mode using the G7 Modes Menu
- Using the up and down arrow buttons, scroll through the menu, then select Modes by pressing the OK button.The Modes menu opens.
- Using the up and down buttons, scroll through the menu and select a mode by pressing the OK button.Note:
Your device’s active settings are flagged with >.
A prompt opens to confirm you want to switch to the selected mode.
- Select Yes by pressing the up arrow button.Note: If the mode selected uses a pump, G7 tests the pump flow before entering the mode.
- Follow the steps on G7's screen to complete the block test, blocking and unblocking the gas flow when prompted by your device.
- Select OK to cancel the flow test at any time. If the block test fails, check G7's tubing and try to activate the mode again.When your device successfully activates the selected mode, the main screen's color scheme inverts and the banner indicates the mode selected.
Depending on the mode selected, G7 remains in the mode until it times out according to the settings in the configuration profile, or until you manually exit the mode.
To manually exit a mode and return to normal operation, open the Modes menu, then select Normal.
