Uninstalling G7 EXO Pump Components
Important:
Do not discard your G7 EXO Pump components. Device components can be re‑installed in G7 EXO as your area monitoring requirements change.
- Remove the pump module:
Place G7 EXO on its side with the pump module facing upwards.
- Remove the screws from the pump module and set them aside.
- Carefully lift the module, using your fingers to detach the quick connect from G7 EXO.
- Remove and set the pump module aside with the other pump components.
Stand G7 EXO upright.
- Remove the pump gas chamber:
- Slide the chamber out of the front enclosure, using your fingers to carefully detach the pump gas chamber coupling from G7 EXO's inlet tubing.
Figure 2. Ideal tubing position for optimal gas flow Note:You may need to gently unclip or adjust the tubing by sliding it through the tube clamp to shorten the loop to allow for the movement of the pump gas chamber.
Important:During any adjustment of the inlet tubing and clamp, take care not to dislodge the display ribbon cable connector. If you dislodge the connector, gently reconnect it before proceeding.
- Slide the chamber out of the front enclosure, using your fingers to carefully detach the pump gas chamber coupling from G7 EXO's inlet tubing.
The device is ready for the installation of new components. For instructions on installing upgraded G7 EXO Diffusion components, see Installing G7 EXO Diffusion Components.
