Installing the Gas Expansion Module
- Check inside the module opening to see if the inlet tubing is
crimped. Ensure the clip is correctly attached and, if necessary, gently adjust
the inlet tubing by sliding it through the tube clamp to elongate the loop.Note: During any adjustment of the inlet tubing and clamp, take care not to dislodge the display ribbon cable connector. If you dislodge the connector, gently reconnect it before proceeding.
- Insert the gas expansion module's ribbon cable into the connector on EXO's board. The ribbon cable connector should face towards the outside of EXO and the key on the ribbon cable connector should align with the corresponding slot in EXO's board.Ensure the ribbon cable is not pinched between EXO's frame and the gas expansion module.
- Attach the gas expansion module to EXO using the inlet tubing quick-connect.
- Lower the gas expansion module
into the opening until it is flush with EXO's frame. Ensure that the inlet
tubing remains tucked under EXO's internal frame.CAUTION: The gas expansion module is designed to lie flush with the opening. Make sure the inlet tubing is not pinched between the module and EXO's frame. DO NOT force or otherwise use undue pressure when lowering the module into place.
- Using a screwdriver, secure the gas expansion module to EXO using the screws provided, ensuring they are snug but not over-tight. The recommended torque level is 6-8in.lbs (0.7-0.9 N.m).